Call 131 546 and get a quote or book a New Home Inspection for Ando online today.
Jim’s Building Inspections conducts new home inspections (also known as new construction inspections) in Ando and the surrounding areas. Our expert consultants can assist you with every stage of your build and ensure your new build meets your expectations and the necessary standards.
Our local consultants have extensive experience and hold public liability and professional indemnity insurance—meaning you can have peace of mind when you acquire the services of a Jim’s Building Inspector.
We offer same day service for New Home Inspections in Ando and provide written reports via email within 24 hours of the inspection being conducted.
New Home Inspection Checklist
There are four key inspection stages which can be carried out for New Home Inspections:
1. Slab Stage
The slab stage or the base stage inspection is essential in the inspection process. Finished concrete is inspected to ensure there is an even and consistent finish. The surface should not be powdery or flakey. Levels are checked to confirm the slab has been installed within allowable deviation in the over level across and room or the entire build. The edge rebate is checked to ensure it is not “honeycombed” and there is no evidence of steel reinforcement protruding as it must have at least 40mm concrete coverage. The vapour barrier must extend past the poured concrete slab with adequate overlap left so that it extends up the side wall of the slab past the final finished ground level once the construction is completed.
2. Frame Stage
Frame stage inspections are conducted providing an independent assessment of the works to confirm they have been completed ready for stage payment. Internal checks and company appointed inspections are supported with a fresh and focussed and our review monitors the frame with respect to the approved construction methods stipulated in Australian Standard 1684.2 and the Engineers design requirements as detailed on the Approved Plans.
The installation of windows and door frames are checked at this stage. Frame positioning in relation to the supporting slab is checked with any overhanging tolerances along with load bearing timbers, lintels and orientation of Jack Studs above openings. Items such as the correct number of timber blocks and their securing method are checked along with all bracing, mechanical fasteners, tie downs and anchors.
3. Lockup
At this stage we inspect the roofing that is installed to ensure it is complete and free of defects and damage, all flashings are installed. A visual inspection is carried out to check the installation of Flashings. Brick work is checked for correct installation. All windows and doors are installed with the correct fixings using appropriate blocks and the frame straight, plumb and true.
The installed plaster to the ceilings, wall linings and fitted cornice is checked to ensure it is installed to acceptable standards. Waterproof membrane to showers & wet areas are inspected to ensure they are correctly installed and comply with the requirements of the Building Code.
4. Handover
Handover Inspections require an exhaustive check of the construction. At handover inspection we check that all the work completed “In a proper and workman like manner” ensuring that the workmanship is at an industry standard. The construction of the dwelling needs to reflect the Approved Plans and we check that all components of the building comply with relevant Australian Standards and Building Codes.
Handover or Final stage inspections are also called Practical Completion Inspections (PCI) and Pre Handover Inspections. Handover inspections are generally carried out on new homes when construction of the entire home has been completed and all internal fittings, fixtures and finishes have been installed and applied inside the home compliant with the relevant building plans and specifications.
To arrange a quote or a building inspection for a property in Ando, call Jim’s Building Inspections on 131 546.
Or book your Ando New Home Inspection service online. Reports can be delivered within 24 hours of inspection.
Safety Reversal Check For Automatic Garage Door
In most houses, the largest moving object is a garage door. Newer garage doors are often operated remotely through radio controls, electrical systems, pulleys and motors. Serious injury or death from being hit by a closing garage door or from bein...Read more
Three Simple Ways To Fight Mould
Some things are out of our control. Others are in our control. Thus, when speaking about mould, there are many things we can do. One: Root causes. Find them. A good place to start: Jim’s Building Inspections. When mould is found by experts it’...Read more
Things to consider when building your first home
You might decide that rather than buying an established property as your first home, it would better suit you to build. Building your first home can be both an exciting and overwhelming experience. Building allows you to customise your home from t...Read more
Fact - Termites Hate Good Building Inspectors
A good building inspector knows how to find termite issues. A bad building inspector, by way of contrast, is a termite’s best friend. When Joe Blow (not his real name) bought a two-bedroom 1920s terrace in Sydney’s inner west for around $1 mil...Read more
What Victoria’s New Tenancy Laws Mean For Landlords
Victoria’s new tenancy laws mean that landlords need to pay extra attention to basic standards, especially relating to health and safety. These include (but are not limited to) providing functioning heaters, stoves and even deadlocks. Furthermore, ...Read more
What is franchising?
Franchising is the practice of using another business’s successful business model. By replicating a successful model, the new business owner or franchisee has a greater level of incentive than an employee, they directly benefit from the effort they...Read more
Building? Here Are Mark Campbell's Lessons Learned
“My rationale for building new was threefold,” writes Mark Campbell, a working-class Aussie. “Firstly, it enabled me to have control over the end product and it made sense from an investment perspective because I could maximise depreciation and...Read more
What's involved in a home inspection?
Most of the time we never get to meet our clients face to face and only a small handful are ever able to come along to the home inspections we organise. So there is often a bit of mystery around what exactly we do during a home inspection. ...Read more
Am I An Owner Builder?
Whether you are or aren’t an owner builder can sometimes be a tricky concept to get your head around. Even if you didn’t personally lift a hammer, but rather project managed different trades to do the work, – you are still, legally, the owne...Read more
Re-stumping red flags
A guide to Re-Stumping Re-stumping - or re-blocking as it's known in Victoria - is big business in Australia and can be a very costly exercise, particularly if you don't know what you're looking at and you don't understand what you've bought into....Read more