Call 131546 and get a quote or book a New Home Inspection for Kenwick online today.
Jim’s Building Inspections conducts new home inspections (also known as new construction inspections) in Kenwick and the surrounding areas. Our expert consultants can assist you with every stage of your build and ensure your new build meets your expectations and the necessary standards.
Our local consultants have extensive experience and hold public liability and professional indemnity insurance—meaning you can have peace of mind when you acquire the services of a Jim’s Building Inspector.
We offer same day service for New Home Inspections in Kenwick and provide written reports via email within 24 hours of the inspection being conducted.
New Home Inspection Checklist
There are four key inspection stages which can be carried out for New Home Inspections:
Slab Stage
The slab stage or the base stage inspection is essential in the inspection process. Finished concrete is inspected to ensure there is an even and consistent finish. The surface should not be powdery or flakey. Levels are checked to confirm the slab has been installed within allowable deviation in the over level across and room or the entire build. The edge rebate is checked to ensure it is not “honeycombed” and there is no evidence of steel reinforcement protruding as it must have at least 40mm concrete coverage. The vapour barrier must extend past the poured concrete slab with adequate overlap left so that it extends up the side wall of the slab past the final finished ground level once the construction is completed.
Frame Stage
Frame stage inspections are conducted providing an independent assessment of the works to confirm they have been completed ready for stage payment. Internal checks and company appointed inspections are supported with a fresh and focussed and our review monitors the frame with respect to the approved construction methods stipulated in Australian Standard 1684.2 and the Engineers design requirements as detailed on the Approved Plans.
The installation of windows and door frames are checked at this stage. Frame positioning in relation to the supporting slab is checked with any overhanging tolerances along with load bearing timbers, lintels and orientation of Jack Studs above openings. Items such as the correct number of timber blocks and their securing method are checked along with all bracing, mechanical fasteners, tie downs and anchors.
Lockup
At this stage we inspect the roofing that is installed to ensure it is complete and free of defects and damage, all flashings are installed. A visual inspection is carried out to check the installation of Flashings. Brick work is checked for correct installation. All windows and doors are installed with the correct fixings using appropriate blocks and the frame straight, plumb and true.
The installed plaster to the ceilings, wall linings and fitted cornice is checked to ensure it is installed to acceptable standards. Waterproof membrane to showers & wet areas are inspected to ensure they are correctly installed and comply with the requirements of the Building Code.
Handover
Handover Inspections require an exhaustive check of the construction. At handover inspection we check that all the work completed “In a proper and workman like manner” ensuring that the workmanship is at an industry standard. The construction of the dwelling needs to reflect the Approved Plans and we check that all components of the building comply with relevant Australian Standards and Building Codes.
Handover or Final stage inspections are also called Practical Completion Inspections (PCI) and Pre Handover Inspections. Handover inspections are generally carried out on new homes when construction of the entire home has been completed and all internal fittings, fixtures and finishes have been installed and applied inside the home compliant with the relevant building plans and specifications.
To arrange a quote or a building inspection for a property in Kenwick, call Jim’s Building Inspections on 131546.
Or book your Kenwick New Home Inspection service online. Reports can be delivered within 24 hours of inspection.
Am I An Owner Builder?
Whether you are or aren’t an owner builder can sometimes be a tricky concept to get your head around. Even if you didn’t personally lift a hammer, but rather project managed different trades to do the work, – you are still, legally, the owne...Read more
To Buy Or Not To Buy (Off The Plan)
To buy or not to buy (off the plan) is an important issue for an increasing number of new homebuyers and property investors. When done responsibly with professional guidance (offered by Jim’s Building Inspections, for example) it can be a positi...Read more
Go With Licensed Pre-Property Inspectors
What makes a good pre-property inspector? Sourceable’s Howard Ryan writes: ‘To do the job properly, a qualified building inspector will have extensive knowledge of the Building Code of Australia, the Building Act, the Building Regulations and var...Read more
Is Your Smoke Alarm Up To Scratch
Fires can spread rapidly (in less than five minutes) through your house, according to findings from a Fire & Rescue NSW report. Interesting also is that homeowners are encouraged to look at how many fire alarms in their house to cover all potenti...Read more
The Science Of Inspections
There’s a science to property inspections. Seriously. Because while your average inspector can and does spot problems, a trained inspector can find problems behind problems and other easy-to-miss issues. What’s more, he or she is less likely t...Read more
Inadequate Site and subfloor drainage
A sub-floor is the structure and crawl space between the lowest floor and the ground. High moisture levels in these areas promote fungal decay and other timber pests such as termites. All sub-floors and crawl spaces should be considered as having ...Read more
Common defects found in homes
Are you buying a home or investment property? Here are some of the common defects that our building inspectors in homes. Termite damage The advantages of getting a vendor report before putting your house on the market. Termite damage was found ...Read more
Building Inspectors Break Secrets
Building inspectors break secrets. It’s their job to do so and we wouldn’t have it any other way. They’re in one very real sense property detectives. It’s fraudulent for a vendor to knowingly conceal defects according to the law. This incl...Read more
Do you think that property you are looking to buy has asbestos?
If the house you are looking to buy was built or renovated before 1990, it is likely that it will contain some form of asbestos-containing materials. Did you know that approximately one-third of homes built in Australia contain asbestos products? ...Read more
The Politics Of Smoke Alarms
From 1993 to 2015, CSIRO conducted tests on smoke alarms but the public is yet to read the findings. This comes at a time when activists want ionised smoke alarms banned due to alleged issues with response times to common fires. In America, the alarm...Read more